Ethernet Settings

Step 1: Change Adapter Settings

Open Network Connections
- Press Win + R, type ncpa.cpl, and click OK.
Modify Ethernet Properties
- Right-click your Ethernet connection and select Properties.
YOU ONLY NEED THESE 2 TICKED THEN HIT OK
Ensure the Correct Options Are Selected
- In the Ethernet Properties, make sure only the two required options are selected.
- Once confirmed, click Configure to access the advanced settings.
- Apply the following changes:
  Advanced Tab Settings
  - Advanced EEE: Disabled
  - ARP Offload: Disabled
  - Flow Control: Disabled
  - IPv4 Checksum Offload: Disabled
  - Large Send Offload v2 (IPv6): Disabled
  - Network Address: Not Present
  - TCP Checksum Offload (IPv6): Disabled
  - UDP Checksum Offload (IPv6): Disabled
If a setting is unavailable, skip it.
Restart Your PC

Step 2: Flush and Reset Network Settings

Open Command Prompt (Admin)
- Press Win + X, select Command Prompt (Admin) or Windows Terminal (Admin).
Enter Commands (30-Second Delay Between Each)
- ipconfig /flushdns
- ipconfig /registerdns
- ipconfig /release
- ipconfig /renew
- netsh winsock reset
Restart Your PC
Repeat Commands (With 5-Second Delay)
- Open Command Prompt (Admin) again and enter:
  - arp -d
  - netsh interface IP delete arpcache
Restart Your PC Again

Step 3: Restart Your Router

Step 4: Install and Configure a VPN

https://windscribe.com/install/desktop/windows

Download and Install Windscribe
- Use your credentials created after buying windscribe.
Login to Windscribe
- Navigate to the WireGuard section.
- Select Stealth Mode.
VPN Usage
- Use the VPN for 14 days after spoofing.
- After 14 days, you can disable the VPN and play as usual.

IMPORTANT: These steps ensure optimal performance and minimize detection risks. Always follow them carefully!

Last updated 5 months ago